Chapter 3 - Expressway Driving
Florida Drivers Handbook - Chapter 3
Expressway Driving
You are Here: Traffic School » Florida Driver Handbook » Chapter 3 » Expressway Driving
The Florida drivers handbook is your guide to getting a Florida drivers license. Inside the drivers manual you will find driving laws, explanations of how to get your drivers license, and details of the different types of drivers licenses Florida offers.
Chapter 3 - Expressway Driving
This section of the Florida Driver Handbook covers Expressway Driving techniques and laws.
Topics Addressed in Chapter 3 of the Florida Driver Handbook include:
« Back to Driver Handbook Table of Contents
Expressway Driving
Expressways - also called interstate highways, freeways, and turnpikes are multiple-lane roads with no stop signs, traffic lights, or railroad crossings. For these reasons, expressways can give you a fast, safe way to get where you need to go.
Pedestrians, hitchhikers, bicycles, animal-drawn vehicles or motor-driven cycles and motor scooters with 150 cubic centimeter displacement or less are not allowed on expressways.
Entering and Leaving Expressways
Vehicles can enter and leave expressways only at certain points. Because expressway traffic is usually moving at or close to the maximum speed allowed, you need to know how to enter and exit safely.
All expressway entrances have three basic parts: an entrance ramp, an acceleration lane, and a merging area. Follow these guidelines to enter an expressway safely:
- On the entrance ramp, begin checking for an opening in traffic. Signal for your turn.
- As the ramp straightens into the acceleration lane, speed up. Try to adjust your speed so that you can move into the traffic when you reach the end of the acceleration lane.
- Merge into traffic when you can do so safely. You must yield the right-of-way to traffic on the expressway. You cannot always count on other drivers moving over to give you room to enter, but do not stop on an acceleration lane unless traffic is too heavy and there is no space for you to enter safely.
When leaving an expressway:
- Get into the exit lane. Posted signs will tell you which one. Most expressway exits are from the right lane.
- Signal your intention to leave the expressway by using your turn signal.
- Slow down as soon as you are off the expressway. Check the posted safe speed for the exit ramp.
- Do not make last-minute turns into an exit. If you go past your exit, you must go to the next one.
Expressway Safety Reminders
- Plan your trip. Know just where you will get on and get off.
- Drive in the right lane and pass on the left. If there are three lanes, use the right lane for lower speed driving, the left for passing. If you stay in the right lane, watch for cars entering the expressway. Adjust your speed or move into the center lane so they can enter safely.
- Never stop on the pavement, shoulder, or connecting ramp of an expressway except in an emergency. If your vehicle breaks down, it may be parked on the side of the expressway (completely off the pavement) for no more than six hours. Raise your hood and tie a white cloth to your antenna or left door handle to show you need help.
- Never back up on an expressway entrance ramp or exit ramp. The only exception to this would be if you are trying to enter an expressway through an exit. In this case, you would see a "WRONG WAY" or "DO NOT ENTER" sign. Then you must back up or turn around.
- Do not cross, drive on or park on the median strip.
- Do not follow too closely. Rear end collisions are the greatest danger on expressways. Always leave room for emergency stops.
- Stop driving when you feel tired. On long trips the hum of the engine and your lack of movement can make you feel sleepy. Stop for a cup of coffee, a short walk, or a nap. Do not risk falling asleep at the wheel.
Night Driving
You will need to drive with extra care at night. You cannot see as far ahead or to the side, and glare from oncoming cars can reduce your vision even more. Follow these guidelines for driving at night:
- Use your headlights (low beam or high beam) between the hours of sunset and sunrise.
- Low beam headlamps are only effective for speeds up to 20-25 MPH. You must use special care when driving faster than these speeds, since you are unable to detect pedestrians, bicyclists and others.
- High beam headlights can reveal objects up to a distance of at least 450 feet and are most effective for speeds faster than 25 MPH.
- Don’t use high-beam headlights within 500 feet of oncoming vehicles.
- If you are behind other vehicles, use low beams when you are within 300 feet of the vehicle ahead.
- When leaving a brightly lit place, drive slowly until your eyes adjust to the darkness.
- If a vehicle comes toward you with high beams, flash your lights to high beam and back to low beam once.
- Don’t look directly at oncoming headlights. Instead, watch the right edge of your lane. Look quickly to be sure of the other vehicle’s position every few seconds.
- Drive as far to the right as you can if a vehicle with one light comes toward you.
Disclaimer: Please get an official copy of the Florida Driver Handbook by visiting your local DMV Office. While we try, we cannot guarantee the accuracy of the online verison provided here.